![]() That, unfortunately means you need a new sub unless you can procure the right amp for it. If you still hear little to no bass at the -30db mark, then I would suspect a dud amplifier in the subwoofer. NOTE: TURN OFF SPEAKERS A AND B BEFORE DOING THIS OR YOU COULD DAMAGE YOUR SUBWOOFER DUE TO EXCESSIVE OUTPUT LEVELS. As a secondary test, you could also use the L/R outputs to your sub's line level inputs. Make sure your AVR isn't set to option #1. ![]() Good for movies or if you have your sub placed (and phased) properly to avoid the standing waves noted in #2. Best for clear reproduction of bass and avoidance of standing waves between the mains and the subwoofer.ģ) BOTH: Outputs bass to all possible main channel speakers and the subwoofer simultaneously. ![]() Bass below this frequency will be rolled off at a roughly 12db/octave slope to the front speakers. Same as using Pure Direct mode.Ģ) SWFR (Subwoofer): This will output the bass that is below the selected crossover setting to the subwoofer only. /rebates/&252fboston-acoustics-vr-500-subwoofer-manual. Yamaha AVRs have three possible settings for subwoofer output:ġ) Front: This will output ONLY to your front speakers, ignoring your subwoofer.
0 Comments
Leave a Reply. |